CSD87350Q5D

www.ti.com

SLPS288C

– MARCH 2011 – REVISED OCTOBER 2011

The CSD87350Q5D NexFET

™ power block is an optimized design for synchronous buck applications using 5V

gate drive. The Control FET and Sync FET silicon are parametrically tuned to yield the lowest power loss and

highest system efficiency. As a result, a new rating method is needed which is tailored towards a more systems

centric environment. System level performance curves such as Power Loss, Safe Operating Area, and

normalized graphs allow engineers to predict the product performance in the actual application.

Power Loss Curves

In an effort to simplify the design process for engineers, Texas Instruments has provided measured power loss

performance curves. Figure 1 plots the power loss of the CSD87350Q5D as a function of load current. This curve

is measured by configuring and running the CSD87350Q5D as it would be in the final application (see

Figure 32).The measured power loss is the CSD87350Q5D loss and consists of both input conversion loss and

gate drive loss. Equation 1 is used to generate the power loss curve.

(1)

The power loss curve in Figure 1 is measured at the maximum recommended junction temperatures of 125

°C

under isothermal test conditions.

Safe Operating Curves (SOA)

The SOA curves in the CSD87350Q5D data sheet provides guidance on the temperature boundaries within an

operating system by incorporating the thermal resistance and system power loss. Figure 3 to Figure 5 outline the

temperature and airflow conditions required for a given load current. The area under the curve dictates the safe

operating area. All the curves are based on measurements made on a PCB design with dimensions of 4

” (W) x

3.5

” (L) x 0.062” (T) and 6 copper layers of 1 oz. copper thickness

Normalized Curves

The normalized curves in the CSD87350Q5D data sheet provides guidance on the Power Loss and SOA

adjustments based on their application specific needs. These curves show how the power loss and SOA

boundaries will adjust for a given set of systems conditions. The primary Y-axis is the normalized change in

power loss and the secondary Y-axis is the change is system temperature required in order to comply with the

SOA curve. The change in power loss is a multiplier for the Power Loss curve and the change in temperature is

subtracted from the SOA curve.

Figure 32. Typical Application

Copyright

© 2011, Texas Instruments Incorporated

Submit Documentation Feedback

11