5

www.fairchildsemi.com

Note 4: An external driver must source at least the specified current to switch from LOW-to-HIGH.

Note 5: An external driver must sink at least the specified current to switch from HIGH-to-LOW.

Note 7: Characterized in SSOP package. Guaranteed parameter, but not tested.

Note 8: Max number of outputs defined as (n). n

1 data inputs are driven 0V to 3V. Output under test held LOW.

AC Electrical Characteristics

Note 9: Skew is defined as the absolute value of the difference between the actual propagation delay for any two separate outputs of the same device. The

Note 10: Capacitance is measured at frequency f

1 MHz, per MIL-STD-883, Method 3012.

Symbol

Parameter

Units

Conditions

(V)

Min

Max

Power Supply Current

3.6

0.19

mA

Outputs Disabled

Increase in Power Supply Current

3.6

0.2

mA

(Note 6)

Symbol

Parameter

Units

Conditions

(V)

Min

Typ

Max

3.3

0.8

V

(Note 8)

3.3

0.8

V

(Note 8)

Symbol

Parameter

Units

Min

Max

Min

Max

Propagation Delay

1.3

4.8

1.3

5.3

ns

1.4

4.8

1.4

5.1

Propagation Delay

1.7

5.0

1.7

5.1

ns

1.4

5.1

1.4

5.8

Output Enable Time

1.6

5.0

1.6

6.0

ns

1.0

5.4

1.0

6.6

Output Disable Time

1.6

5.1

1.6

5.0

ns

1.8

5.4

1.8

5.7

1.0

0.8

ns

1.0

1.1

ns

LE Pulse Width

3.0

3.0

ns

Output to Output Skew (Note 9)

1.0

1.0

ns

1.0

1.0

Symbol

Parameter

Conditions

Typical

Units

Input Capacitance

4pF

Output Capacitance

8pF