© TT electronics plc

General Note

TT Electronics reserves the right to make changes in product specification without

notice or liability. All information is subject to TT Electronics’ own data and is

considered accurate at time of going to print.

Issue A

09/2016 Page 2

TT Electronics | Optek Technology, Inc.

1645 Wallace Drive, Ste. 130, Carrollton, TX USA 75006 |Ph: +1 972 323 2200

www.ttelectronics.com | sensors@ttelectronics.com

OPV382

Storage Temperature Range

-40° to +100° C

Operating Temperature Range

0° to +85° C

Lead Soldering Temperature [1/16 inch (1.6mm) from case for 5 sec with soldering iron]

Maximum Forward Peak Current, Continuous

12 mA

Maximum Reverse Voltage

5 V

Maximum Forward Current, pulsed (1µs P.W., 10% D.C.)

48 mA

Electrical Specifications

SYMBOL

PARAMETER

MIN

TYP

MAX

UNITS

TEST CONDITIONS

Total Power Out

1.5

mW

Threshold Current

3.0

mA

Note 2

Forward Voltage

2.2

V

Reverse Current

100

nA

Series Resistance

20

55

ohms

Note 3



Slope Efficiency

0.28

mW/mA

Note 4



Wavelength

840

860

nm



Optical Bandwidth

0.85

nm



Beam Divergence

6

Degrees FWHM

T

Temp Coefficient of Slope Efficiency

-0.50

%/°C

(0° - 70°C), Note 4

/T

Temp Coefficient of Wavelength

0.06

nm/°C

(0° - 70°C)

Temp Variance of Threshold Current

±1.0

mA

(0° - 70°C), Note 2

Temp Coefficient for Forward Voltage

-2.5

mV/°C

(0° - 70°C)

NOTES:

(1)

RMA flux is recommended. Solder dwell time can be increased to 10 seconds when flow soldering.

(2)

Threshold Current is based on the two line intersection method specified in Telcordia GR-468-Core. Line 1 from 4 mA to 6 mA. Line 2 from 0 mA to 0.5 mA.

(3)

Series Resistance is the slope of the Voltage-Current line from 5 to 8 mA.

(4)

Slope efficiency, is the slope of the best fit LI line from 5 mA to 8 mA with 0.25mA test intervals.