www.ti.com

DETAILED DESCRIPTION

TPIC9201

MICROCONTROLLER POWER SUPPLY

AND MULTIPLE LOW-SIDE DRIVER

SLIS115B – APRIL 2005 – REVISED JUNE 2006

The open-drain power-on reset (RST) pin remains low until the regulator exceeds the set threshold, and the

RST is asserted high. This signifies to the microcontroller that serial communications can be initiated to the

TPIC9201.

The serial communications is an 8-bit format, with data transfer synchronized using a serial clock from the

microcontroller. A single register controls all the outputs (one bit per output). The default value is zero (OFF). If

an output requires pulse width modulation (PWM) function, the register must be updated at a rate faster than the

desired PWM frequency. OUT1 can be controlled by serial input from the microcontroller or with the dedicated

enable (EN1) pin. If EN1 is pulled low or left open, the serial input through the shift register controls OUT1. If

EN1 is pulled high, OUT1 always is turned on, and the serial input for OUT1 is ignored.

The SYN input translates the image of the mains voltage through the secondary of the transformer. The SYN

input has a resistor to protect from high currents into the IC. The zero-voltage synchronization output translates

the AC-line cycle frequency into a low-frequency clock, which can be used for a timing reference and to help

power loads on the AC-line peak voltage (to reduce in-rush currents).

If RST is asserted, all outputs are turned OFF internally, and the input register is reset to all zeroes. The

microcontroller must write to the register to turn the outputs ON again.

4

Submit Documentation Feedback