FM20L08 - Extended Temp.
Rev. 1.4
Oct. 2005
Page 7 of 14
Software Write Protect Timing
CE
A(16:0)
WE
DQ(7:0)
05555
Data
Data
OE
1AAAA
03333
1CCCC
100FF
0FF00
1AAAA
1CCCC
0FF00
00000
SRAM Drop-In Replacement
The FM20L08 has been designed to be a drop-in
replacement for standard asynchronous SRAMs. The
device does not require /CE to toggle for each new
address. /CE may remain low indefinitely while VDD
is applied. When /CE is low, the device automatically
detects address changes and a new access is begun. It
also allows page mode operation at speeds up to
33MHz.
Although /CE may be held low for extended
periods of time, the pin should not be tied to
ground or held low during power cycles.
/CE
must be pulled high and allowed to track VDD
during powerup and powerdown cycles. It is the
user’s responsibility to ensure that chip enable is
high to prevent incorrect operation.
Figure 3
shows a pullup resistor on /CE which will keep the
pin high during power cycles assuming the
MCU/MPU
pin
tri-states
during
the
reset
condition.
The pullup resistor value should be
chosen to ensure the /CE pin tracks VDD yet a high
enough value that the current drawn when /CE is
low is not an issue.
Figure 3. Use of Pullup Resistor on /CE
For applications that require the lowest power
consumption, the /CE signal should be active only
during memory accesses. Due to the external pullup
resistor, some supply current will be drawn while /CE
is low. When /CE is high, the device draws no more
than the maximum standby current ISB.
The FM20L08 is backward compatible with the
256Kbit FM18L08 device.
So, operating the
FM20L08 with /CE toggling low on every address is
perfectly acceptable.
CE
WE
OE
A(16:0)
DQ
FM20L08
VDD
MCU/
MPU
R
Spanish ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
