Visit us at

www.anaren.com

USA/Canada:

Toll Free:

Europe:

Asia:

(315) 432-8909

(800) 411-6596

+44 2392-232392

+86 512-62749282

Model PD0922J7575D2HF

Rev B

Mounting Configuration:

In order for Xinger surface mount components to work optimally, the proper impedance transmission lines must be

used to connect to the RF ports. If this condition is not satisfied, insertion loss, Isolation and VSWR may not meet

published specifications.

All of the Xinger components are constructed from organic PTFE based composites which possess excellent

electrical and mechanical stability. Xinger components are compliant to a variety of ROHS and Green standards and

ready for Pb-free soldering processes. Pads are Gold plated with a Nickel barrier.

An example of the PCB footprint used in the testing of these parts is shown below. In specific designs, the

transmission line widths need to be adjusted to the unique dielectric coefficients and thicknesses as well as varying

pick and place equipment tolerances. In addition, since the PD0922J7575D2HF is a Wilkinson power divider,

external 0402 150

and 300

resistors must be mounted in locations R1 and R2 respectively, as shown in the

Figure below.

Pad Footprint w/ 0402 Resistor Locations

6x .41

6x .33

.04

4x

.25

.66

Plated thru

holes to ground

3x Transmission

lines

R2

R1

Circuit Pattern

Footprint Pad (s)

Solder Resist

Mounting Footprint

Dimensions are in Millimeters